Belt Adjustment - SPORTSTECH F15 Mode D'emploi

The running belt is pre-adjusted to the running deck at the factory, but after prolonged use it can
stretch and require readjustment. To adjust the belt, turn on the main power switch of the treadmill
and let the belt run at a speed of 8-10 KPH. Use the 6 mm Allen Wrench provided to turn the rear
roller adjustment bolts in order to centre the belt. If the running belt is shifting to the left, turn the left
adjustment bolt 1/4 turn clockwise, and the running belt should start to correct itself.
If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn clockwise,
and the belt should start to correct itself. Keep turning the adjustment bolts until the running belt is
properly centered.
If the running belt is slipping during use, turn off and unplug the treadmill. Using the 6 mm Allen
Wrench provided, turn both left and right rear roller adjustment bolts 1/4 turn clockwise, then turn
the main power switch back on and run the treadmill at a speed of 8-10 KPH. Run on to the running
belt to determine if the belt is still slipping. Repeat this procedure until the belt no longer slips.

BELT ADJUSTMENT

44
Werkzeug:
Inbusschlüssel
Werkzeug:
Inbusschlüssel
Werkezug:
Inbusschlüssel