Block Function - LaCimbali M26 Utilisation Et Installation

BLOCK FUNCTION

When the machine is blocked, a warning message appears
on the display: if the key
on the display are followed, the wash cycle is performed
and the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
GROUP 1 LOCKED
EXECUTE WASHING
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.
CHANGING THE WATER IN THE BOILER - Procedure to carry out at least once a day
DT version with display. Keep a hot water distributor key
(11) pressed down for approximately 5 seconds.
The following message will be displayed: "WATER CHANGE
...%". The water from the boiler will drain from the hot water
nozzle (20
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
C version / DT version without display. Continuously
dispense hot water (pressing the appropriate button) until
at least 5 liters of water have been used for a machine
with 2 groups, and 8 liters for a machine with 3 groups.
02_M26_UNICO_1817.indd 24
is pressed and the instructions
If the key is pressed, the previous message will be
integrated as shown:
INSERT FILTER HOLDER
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The
block messages for groups still to be washed appear in
alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
11
20
24 EN
GROUP 1
03/05/2018 16:48:32