Description Display Symbols (Only Dt Version With Display); Water Level; Bluetooth; Technical Programming Menu - LaCimbali M26 Utilisation Et Installation

11. Description display symbols (only DT version with display)

WATER LEVEL

This symbol indicates the boiler water level.
During the loading phase, the bottom part of the
icon blinks.
When the optimum level is reached, the symbol
looks like this:
RESISTANCE
This symbol (dark inside) indicates that the
resistance is activated and functioning.
When the boiler pressure reaches the set value, the icon
looks like this
When the machine is in operation, the two icons
alternate on the display, indicating the presence
of the electric heating.
This indicates that the heating resistance has
been disabled.
Note: the customer cannot switch on or switch
off the electric heating.
When the on/off function is programmed, the
electric heating takes place automatically.
SERVICE BOILER PRESSURE
This symbol indicates the boiler pressure value.
If the key is pressed for about 3", the pressure
gauge will be displayed analogically. This will be
shown on the display:
Press and hold down the
seconds to return to the regular display mode.
02_M26_UNICO_1817.indd 13
.
(light inside).
key for about 3
This symbol indicates that the machine is pre-
heating or the boiler pressure has dropped below
For the duration of this phase, the display alternates this
symbol with the one indicating the boiler pressure.
The machine has reached the set work pressure and
temperature when the icon
CUP-WARMER (*)
These symbols indicate the power
currently selected by the cup warmer.
no symbol = OFF
WIFI (*)
WIFI connection symbols:
- connected to the network.

BLUETOOTH (*)

These symbols refer to Bluetooth communication:
- the icon indicates the presence of the Bluetooth
- the icon indicates that the machine is communicating
with a Bluetooth grinder/dispenser.
USB
This symbol appears on the display when a USB
pen drive is connected.
SD (*)
This icon indicates the presence of an SD micro
chip in the CPU board of the machine.

TECHNICAL PROGRAMMING MENU

This symbol indicates that the technical
programming menu can be accessed.
(*) The components - * - are applied only in some produit
13 EN
disappears from the display.
= maximum power symbol
03/05/2018 16:48:21