Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• This appliance is designed for
indoor household use only and
at an altitude below 2000 m. The
EN
manufacturer shall not accept any
liability and reserves the right to
cancel the guarantee in the event
of commercial or inappropriate use
or failure to follow the instructions.
• This appliance should not be used
for household and similar use (not
covered by the guarantee) such as:
- Staff kitchen areas in shops,
offices and other working
environments.
- In kitchen areas reserved for
staff in shops, offices and other
professional environments.
- On farms.
- Use by clients of hotels, motels and
other residential environments.
- in guest room environments.
• Your appliance gives off steam
oven gloves, a potholder, etc. if
necessary). Handle the cap by its
central section.
• Never operate the appliance if
the seal is not positioned on the
seal holder or if the seal holder
is not assembled on the lid. It is
essential to operate the appliance
with the cap positioned in the
which can cause burns.
Handle the lid and the
cap
with caution (use
hole in the lid (unless specifically
otherwise stated in the recipe).
WARNING: Be aware
of the risk of injury in
the event of incorrect
use of the appliance.
Take care with the knives of the
Ultrablade knife (F1) and the
kneading/grinding & crushing blade
(F4) when you are cleaning them
and when you empty the bowl, they
are extremely sharp. Be careful
if a hot liquid is poured into the
food processor because it could be
ejected from the appliance due to
it suddenly boiling.
Place the Ultrablade chopper blade
(F1) in the bowl after use.
WARNING: Be careful to avoid any
spillage on the connector during
cleaning, filling or pouring.
WARNING: The heating element
surface is subjected to residual
heat after use.
- Be sure to touch only the handles
of your product (locks D2, handle
of the lid E2 and handle of the
cap E1) during heating and until
complete cooling down.
• Refer to the instructions for
setting the operating times and
speed settings of each accessory
and each programme.
• Refer
to
for assembly and mounting
22
the
instructions
Publicité
Table des Matières
