BIG ASS FANS ESSENCE Installation page 9

9. Connect power supply cable to wiring harness
Plug the male connector (a) on the LED Light wiring harness into
the female connector (b) on the LED light power supply cable.
Pull any excess wire up through the motor shaft. See "Wiring" for
wiring details and a diagram.
10. Install cover plate assembly
If installing both the LED Light Kit and the fan at the same time, continue fan installation on step 9 in the
"Hanging the Fan" section of the complete Installation Guide.
Plug the male wiring harness (a) into the female wiring harness (b) on the cover plate assembly. Ensure all wiring
is tucked inside the extension tube, and then reattach the cover plate assembly to the extension tube.
ATTENTION
a
© 2016 DELTA T LLC ALL RIGHTS RESERVED.
Cover plate
assembly
b
ESS-INST-107-MUL-01 REV. C 12/09/2021
b
a
9