BIG ASS FANS ESSENCE Installation page 2

Installation
WARNING: Disconnect the fan from the power supply before installing the LED light.
If installing both the LED Light Kit and the fan at the same time, proceed to step 3b.
1. Remove cover plate assembly
Carefully unplug the male wiring harness (a) from
the female wiring harness (b) on the cover plate
assembly. Remove the cover plate assembly
from the extension tube.
2. Remove airfoils
Do not discard hardware!
Remove airfoils to allow access to the four screws that hold the lower cover in place.
Airfoil
2
ATTENTION
ATTENTION
© 2016 DELTA T LLC ALL RIGHTS RESERVED.
a
ESS-INST-107-MUL-01 REV. C 12/09/2021
Cover plate
assembly
b