BIG ASS FANS ESSENCE Installation page 7

6. Install mounting plate
Route the wiring harness (a) hanging from the main fan unit through the hole in the center of the mounting plate.
Secure the mounting plate to the bracket on the bottom of the main fan unit with three
(b).
screws
7. Secure LED Light module
Do not touch LEDs or allow to get dirty!
Plug the female connector on the wiring harness (a) into the port (b) on the LED light module. See "Wiring" for
details and a wiring diagram.
Secure the LED light module to the heat deflector. Loosely insert all four 8-32 x 7/16" pan head screws (c), then
tighten them.
LED light
module
b
c
© 2016 DELTA T LLC ALL RIGHTS RESERVED.
a
ATTENTION
ESS-INST-107-MUL-01
8-32 x 7/16" pan head
Mounting
plate
a
b
REV. C 12/09/2021
7