Troubleshooting; Control Display; For The Microwave Oven - Dacor DOC30P977D Série Manuel D'utilisation

Troubleshooting

Troubleshooting
If you experience malfunctions or performance issues, review the tables in this
section to resolve the issue yourself. If you still cannot resolve the issue, call Dacor
Customer Service 833-35-ELITE (833-353-5483).

Control Display

Problem Possible cause
The display A fuse in your home may be
goes blank. blown or the circuit breaker
tripped.
The buttons • There is foreign matter
cannot be caught between the
pressed buttons
properly. • Touch model: There is
moisture on the exterior
• The lock function is set
74 English
DOC30P977DS_DA_DG68-01316A-00_EN.indd 74

For the Microwave Oven

General
The buttons cannot
Solution
be pressed properly.
Replace the fuse or reset the
circuit breaker.
• Remove the foreign
matter and try again.
• Remove the moisture and
The oven does not
try again.
work.
• Check whether the lock
function is set.
The oven stops while
in operation.
Symptom Cause
Foreign matter may
be caught between the
buttons.
For touch models:
Moisture is on the
exterior.
Control lock is activated.
Power is not supplied.
The door is open.
The door open safety
mechanisms are covered
in foreign matter.
The user has opened the
door to turn food over.
Action
Remove the foreign matter and
try again.
Wipe the moisture from the
exterior.
Deactivate Control lock.
Make sure power is supplied.
Make sure the oven is plugged
in. Check if a fuse has been
blown or circuit breaker has
been tripped.
Close the door and try again.
Remove the foreign matter and
try again.
After turning over the food,
press the Start button again to
start operation.
2020-07-07 오후 4:53:37