Connection Between Aer485, Gr Cards And Aerweb; Aer485 Connection With Gr03; Aer485 Connection With Gr03 And Aerweb30 - AERMEC AER485 Mode D'emploi

Connection between AER485, GR cards and AERWEB

AER485 connection with GR03

AER485 connection with GR03 and AerWeb30

The supplied ferrite must be introduced onto the serial connection cable,
positioning it close to the AER485 card. The installation of the ferrite must
be carried out by twisting the cable around the ferrite two times.
The serial connection between AER485
and AerWeb 30, must be carried out
using shielded two-pole cable (connecting
the shielding to earth); the name of the
control board for the serial connection is
CONN1; The poles indicated on the card
represent:
Pole A = POSITIVE POLE;
Pole B = NEGATIVE POLE;
1
2
1
6
FUSE
2
CONN1
Serial connection (MODBUS protocol)
230V 50Hz
~
3
FUSE
CONN1
Key
1 - GR03 card
2 - 10-way flexible flat cable
3 AER485 card
4 - AerWeb 30
Serial connection,
terminals 7 and 8
7
3
Key
1 - GR03 card
2 - 10-way flexible flat cable
3 AER485 card
5 - RS485 serial cable
6 - Serial connection
7 - Ferrite
8 - Pc
Power supply connection,
terminals 10 and 12
230V 50Hz
-
+
~
4
5
8
15