AERMEC AER485 Mode D'emploi page 14

The AER485 accessory allows the in-
terfacing of the Aermec cards, which
equip the NRA/C, NBW, NLW, NRL
series machines, to a communication
network with RS485 electrical standard.
This permits the use of the Modbus RTU
protocol for the remote control of the
machine. The software version of the
display card must be 3.3 or later. This
card is installed on the machine and
connected to the display card.
AER485 card supply
The L, N power supply of the auxiliary
circuit must be connected to the M1
control board of the AER485 card.
14
In general AER485
M1 supply to AER485 card
CONN1
10-way M3 flexible flat cable
AER485 card dimensions
Neutral
Line
FUSE
CONN1
FUSE
CONN1
126
FUSE
CONN1
of the auxiliary circuit