Aer485 Dip Switch Setting - AERMEC AER485 Mode D'emploi

There are 4 dip-switches on the AER485
card known as SW1. These must be su-
itable confi gured based on the display
card version to which it is connected.
Each display card has an address, and
this address must be different from the
address of any other card connected to
the same network. The address range
varies from 1 to 255.
The translation from address value to
Dip setting is shown in the conversion
table. The fi gures from left to right re-
spectively correspond to the Dips from
position 1 to position 8.
The DIP switches have the following va-
lue, according to their position:
DIP ON = 0
DIP OFF = 1
NB To set the address, you need to re-
fer to the binary numeration system. DIP
switch number one has a weight of 20,
which is 1, while DIP switch number 8
has a weight of 27, which is 128.
To calculate the address, add together
all the weights of DIP switches set to
OFF.
Example: DIP switches 3, 6, and 7 are
set to OFF, while the others are set to
ON. The address value is as follows:
4+32+64=100

AER485 Dip Switch setting

DIP-SWITCH (Display version)
For display card with code 3381750
IM00 or HIGHER IM or 3399950 IM00
or HIGHER IM:
1 2 3 4
DIP-SWITCH (Unit address)
FUSE
CONN1
For display card with code 3279650
IM04 or LOWER IM:
ON
OFF
ON
1 2 3 4 5 6 7 8
M3
ON
OFF
1 2 3 4
ON
1 2 3
17