DeFelsko PosiTest HHD Mode D'emploi page 18

Before returning the PosiTest HHD for service –
1.Install a fully charged battery in the correct orientation.
2.Inspect all wires, plugs, and connectors for damage.
3.Power up PosiTest HHD by pressing the power button
4.Reset the PosiTest HHD (See pg. 12).
5.Press and hold power button while activating the trigger.
6.Connect end of electrode rod to ground (earth) lead to
simulate a holiday.
7.If the PosiTest HHD does not activate the Audio and Strobe
alarms or create an arc, remove the battery and return the
PosiTest HHD without the battery for service.
If you must return the PosiTest HHD for service,
IMPORTANT:
please follow the instructions provided at
https://www.defelsko.com/service-support#Service
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTest, PosiTector, and PosiSoft are trademarks of DeFelsko Corporation
registered in the U.S. and in other countries. Other brand or product names are trademarks
or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.
Returning for Service
and Limited Liability
www.defelsko.com
© 2021 DeFelsko Corporation USA All Rights Reserved
.