PRO-POINT PROCUT 80 Manuel page 28

8784480
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S) POSSIBLE CAUSE(S)
Pilot plasma is 1. Compressed air is too low or
not stable
during
2. Electrode of cutting torch or
operation.
3. Connection between ground
4. Cutting speed is too slow.
Cut is at 1. Nozzle or electrode is burnt.
wrong angle.
2. The installation position of
3. Cutting speed is too high.
4. Nozzle axis is not plumb with
Cut is too 1. Cutting speed is too slow.
wide, cut
2. Torch's electrode or nozzle is
quality is poor.
3. Cutting speed is too high.
4. Wrong type of nozzle used.
Workpiece is 1. The cutting speed is too
not cut
through.
2. Torch electrode or nozzle is
3. Cut thickness exceeds the
4. Cutting mouth is not vertical.
5. Leak from the gas circuit
28
80A PROCUT 80 Plasma Cutter
too high.
nozzle is burnt.
cable and workpiece is poor.
nozzle and electrode do not
match.
the plane.
burnt.
rapid.
burnt out.
limit of the cutting unit.
reduces gas/air flow.
SUGGESTED SOLUTION(S)
1. Adjust pressure.
2. Replace electrode or nozzle.
3. Connect firmly.
4. Adjust speed.
1. Replace nozzle or electrode.
2. Correctly install both.
3. Slow down cutting speed.
4. Adjust the torch angle.
1. Accelerate cutting speed.
2. Replace electrode or nozzle.
3. Slow cutting speed. Review
4. Replace with a suitable
nozzle.
1. Slow down the cutting
speed.
2. Replace electrode or
nozzle.
3. Replace with high-power
plasma cutting unit.
4. Adjust cutting mouth angle.
5. Examine and repair the
gas circuit.
For technical questions call 1-800-665-8685
V1.0