Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8784480
•
To cut thin material reduce the amperage until you get the best
quality cut.
•
Use the correct size tip orifice for the amperage being used.
•
For straight cuts use a straight edge or cutting buggy as a guide.
For circles, use a template or circle cutting attachment
•
Check that the front end consumable parts of the plasma cutting
torch are in good condition.
PIERCING
Hold the torch at an angle to the workpiece, pull the trigger to start the
arc and slowly rotate it to an upright position.
When sparks are exiting from the bottom of the workpiece, the arc has pierced
through the material. When the pierce is complete, proceed with cutting.
SAFETY TRIGGER OPERATION
The torch supplied with the machine has a new safety trigger design.
Just pull back on the trigger whilst increasing your grip and you will feel
the trigger move to the ON position. When you release the pressure it
will return to the OFF position.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3.
Exposure to extremely dusty, damp, or corrosive air is damaging to
the plasma cutting unit. In order to prevent possible failure or fault
of this equipment, clean the dust at regular intervals with clean and
dry compressed air.
4.
Follow instructions for lubricating and changing accessories.
5.
Only use accessories intended for use with this tool.
6.
Keep the tool handles clean, dry and free from oil/grease at all times.
7.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the
26
80A PROCUT 80 Plasma Cutter
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
