Maintenance Schedule - PRO-POINT PROCUT 80 Manuel

V1.0
tool. An improperly repaired tool may present a hazard to the
user and/or others.

MAINTENANCE SCHEDULE

Remember that this schedule is based on the assumption that your
machine will be used for its designed purpose. Sustained high-load or
high-temperature operation or use in unusually wet or dusty conditions,
will require more frequent service.
FREQUENCY
Daily
examination
Monthly
examination
Quarterly
examination
Annual
examination
Visit www.princessauto.com for more information
80A PROCUT 80 Plasma Cutter
MAINTENANCE
Check to make sure that the knob and switches on the front
and back panels of the plasma cutting unit are working and
correctly set. Replace a switch or knob that is not working or
cannot be set correctly.
Turn the cutting unit on and note if it is shaking, making any
strange sounds or emitting odours. If there is one of the above
problems, have a qualified technician repair the cutting unit.
Check that the fan rotates and is undamaged. Check for and
remove anything blocking the fan if it doesn't rotate. Have a
qualified service technician repair a damaged fan.
Check that all cable and hose connections are tight. Tighten
if loose. If unable to tighten, replace the connector.
Check to see if the current output cable is damaged. If it is
damaged, have the output cable replaced by a qualified
service technician.
Use dry, compressed air to clear the inside of the cutting unit.
Make sure to blow out dust from the internal components.
Make sure that all hardware is securely tightened on the
cutting unit.
Check to make sure that the current matches the
specifications. Measure with clamp multimeter. Have
the cutting unit serviced if the amperage or voltage is
not correct.
Measure the insulating impedance among the main circuit,
PCB and case, if it is below 1MΩ, the insulation may be
damaged and must be replaced.
8784480
27