PRO-POINT PROCUT 80 Manuel page 16

8784480
1. Twist or tape cables together and prevent coils.
2. Do not drape cables on your body.
3. Keep the welding power source and cables as far away from the
user as practical. A minimum of 24 in. is recommended.
4. Connect the workpiece clamp as close to the weld as possible, but
lay the electrode and workpiece cables away from the user.
5. Use the appropriate current setting during cutting.
6. Avoid long and regular bursts of energy while welding. Apply the
electrode in short strokes and intermittently. This will prevent the
pacemaker from interpreting the signal as a rapid heartbeat.
7. Do not allow the electrode to touch the metal while welding.
8. Wrap the lead cable and ground cable together whenever possible.
9. Keep the lead cable and ground cables on the same side of
your body.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in
a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for
damage. Make sure that all items in the contents are included.
Contents: • Welding Unit
• Ground Lead Set
16
80A PROCUT 80 Plasma Cutter
• J100XC 19 ft Plasma Torch
• Electrode
For technical questions call 1-800-665-8685
• Nozzle
V1.0