Assembly & Installation - PRO-POINT PROCUT 80 Manuel

8784480
J Air Pressure Gauge.
K Continuous Cutting Indicator –The LED will glow when
continuous cutting is selected.
L Gas-Check Indicator – The LED will glow when the gas-check
function is selected. The machine cannot cut when this
function is on.
M Grid Cutting Mode – The LED glows when grid cutting is
selected.
N & O CNC Ports – Connection points for CNC equipment.
P Primary power input cable.
Q Air Inlet – Connection for air hose from a compressor or
compressed gas cylinder. Install a 1/4 in. NPT connector (not
included) to make the connection easier.
R ON/OFF switch
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
INSTALL THE AIR SOURCE
The plasma cutter uses compressed air with the plasma arc to create
an ionized cutting arc. A compressor is the best choice to provide air,
but a cylinder of compressed air may be an option when a compressor
is not available.
1. Follow operating and set up instructions in the compressor's manual
before connecting to the plasma cutter.
2. Connect the air hose to the air inlet (Q) on the back of the
plasma cutter. Use thread sealant to prevent air leaks.
3. Install an air dryer on the compressor air hose to prevent moisture
from reaching the plasma cutter. Remember to compensate for the
slight loss of air pressure the air dryer will cause.
SET UP PROCEDURE FOR PLASMA CUTTING
Please install the machine strictly according to the following steps.
1. Connect the plasma torch to the plasma cutting machine. Insert the
plasma torch cable connector into the torch connection (D) and screw
hand tight. Do not bend the pins inside the torch connector (Fig. 2).
18
80A PROCUT 80 Plasma Cutter
For technical questions call 1-800-665-8685
V1.0