PRO-POINT PROCUT 80 Manuel page 17

V1.0
IDENTIFICATION KEY
A Abnormal Operation Indicator – The LED will glow if the
machine is over current or either under- or over-voltage. The
welding unit will shut down.
B Overheating Indicator - Light shows that the machine has shut
down due to a thermal overload. The light will remain on until
the machine has cooled and is ready for use again.
C Amperage control dial.
D Connector for Torch – Connect the plasma torch cable to the
port. This connection is electrical negative (-).
E Ground Connector – Connect the ground cable to the port
and connect the ground clamp to the workpiece. The port is
electrical positive (+).
F 2T Indicator – Press the button until the LED glows, indicating
2T status is active.
G 4T Indicator - I Press the button until the LED glows, indicating
4T status is active.
H Digital Amperage Meter.
I Input Power - Either the AC 230V or AC 460V LED will glow,
depending on the input power.
Visit www.princessauto.com for more information
80A PROCUT 80 Plasma Cutter 8784480
17