Thermo Scientific mySPIN 6 Manuel D'instructions page 3

and damage the unit. Open lids can cause fluid to be dispersed inside the centrifuge.
20. Do not insert non-standard tubes or other unfamiliar articles into the rotor.
21. Follow all precautions from the Material Safety Data Sheet (MSDS) for any reagent you
use with this instrument.
22. Do not use solvent or flammable liquids near this or other electrical equipment.
23. Do not centrifuge materials that in combination or alone are flammable, explosive, or
corrosive, or may cause any other hazard.
24. Do not operate in a hazardous or flammable environment.
25. Do not use any solvent on the unit that may attack plastic or rubber or cause cracks in
the rotor.
26. Ensure the rotor is protected from corrosion and mechanical damage. The rotor must be
cleaned with a pH-neutral cleaning liquid.
27. Before using any cleaning or decontamination methods except those recommended in
this manual, contact Thermo Fisher Scientific to ensure that the proposed method will
not damage the device.
28. If a single level of hazard protection is required, make sure to use containers that are
tested to Risk Group II or above and that more than one level of protection is provided in
the case of materials of a higher Risk Group.
29. Should the unit fail to work to specification, immediately stop centrifuging and allow the
rotor to come to a complete stop. Clean and troubleshoot the product according to the
instructions under "Trouble Shooting" before any further use of the product. Contact an
authorized dealer or the manufacturer if trouble persists.
30. Always work in a manner which endangers neither the user nor any other person.
31. Repairs are to be performed by trained and authorized service personnel only. Contact
Thermo Fisher Scientific.
32. Opening the instrument housing or improper use of the instrument voids the warranty. If
there is a failure during the warranty period, contact Thermo Fisher Scientific for warranty
service.
33. Do not use units that have not been correctly installed or repaired.
34. Do not attempt to disassemble or modify this product.
35. Store at room temperature in a dry area. Do not expose to sunlight, moisture, or extreme
temperatures for prolonged periods of time.
3