Thermo Scientific mySPIN 6 Manuel D'instructions page 9

Maintenance
mySPIN 6 is normally maintenance-free. Clean unit only when it is not plugged into an electrical
outlet. When necessary, the housing and rotor can be wiped using a damp cloth and a mild,
non-corrosive detergent.
WARNING
Do not use any solvent on the unit that may attack plastic or cause cracks in the rotor. Ensure
the rotor is protected from corrosion and mechanical damage. The rotor must be cleaned with
a neutral cleaning liquid.
NOTICE
Ensure all parts are throughly dry prior to operation.
Trouble Shooting
Trouble
Not working
No light
Excessive
vibration
Noise clicking
sound
Rotor falls off
Possible Cause
• Cord Loose
• Front ON/OFF switch
• Lid not closed
• Rotor not installed correctly
• Rotor not balanced correctly
• Lid not fully closed
• Rotor not attached
Solution
• Check Cord
• Press front ON/OFF switch
• Close Lid
• Reinstall rotor
• Check for tubes of equal
weight and location (see
Operation)
• Close Lid engaging silicon tab
with cover
• Reattach rotor (See Rotor
Replacement)
9