Displaying Stored Results - Medline MDS3001 Guide D'utilisation

8. DISPLAYING STORED RESULTS

a. While the monitor is in Clock Mode, press "MEM" button to display the stored results.
The memory bank will blink and the amount of results in this bank will be displayed.
See picture 8. Press "START" button to change over to other bank. Confirm
your selection by pressing "MEM" button. The current bank can also be confirmed
automatically after 5 seconds with no operation.
b. After selecting the memory bank, the LCD will display the average value of the last
three results in this bank, See picture 8.1. If no result stored, LCD will show picture
8.2.
c. Two seconds later, the most recent result will be displayed with date and time.
See picture 8.3. Irregular heartbeat symbol (if any) and the indicator of blood
pressure classification will blink at the same time. Press "MEM" button again to
review the next result. In this way, the results measured previously in the current
bank can be displayed.
d. When displaying the stored results, the monitor will turn off automatically after
1 minute of no operation. You can also press the button "START" to turn off the
monitor manually.
-22-