Medline MDS3001 Guide D'utilisation page 21

Press "MEM" button to change over to other bank. Confirm your selection by pressing
"START" button. The current bank can also be confirmed automatically after 5
seconds with no operation.
c. After selecting the memory bank, the last result will be displayed with date and time.
See picture 7.2. LCD will show picture 7.3 with current date and time if no memory
stored in the selected bank.
d. The monitor will start to seek zero pressure. See picture 7.4.
e. The monitor inflates the cuff until sufficient pressure has built up for a
measurement. Then the monitor slowly releases air from the cuff and conducts the
measurement. Finally the blood pressure and pulse rate will be calculated and
displayed on the LCD screen. Irregular heartbeat symbol (if any) will blink. See
picture 7.5. The result will be automatically stored in the current memory bank.
f. After measurement, the monitor will turn off automatically after 1 minute of no
operation. Alternatively, you can press the "START" button to turn off the monitor
manually.
g. During measurement, you can press the "START" button to turn off the monitor
manually.
Note: Please consult a health care professional for interpretation of pressure
measurements.
-21-