Lanaform WBPM-110 Manuel D'instructions page 9

over to other bank. Confirm your selection
by pressing "START" button. The current
bank can also be confirmed automatically
after 5 seconds with no operation.
c. If the monitor has stored results, the LCD
will momentarily display the most recent one.
See picture 6-3. If no result has been stored,
zero will appear on LCD. See picture 6-4.
d. Then the monitor starts to seek
zero pressure. See picture 6-5.
e. Then the monitor inflates the cuff until suffi-
cient pressure has built up for a measurement.
Then the monitor slowly releases air from the
cuff and carries out the measurement. Finally
the blood pressure and pulse rate will be
calculated and displayed on the LCD screen.
The blood pressure classification indicator
and Irregular heartbeat symbol (if any) will
blink on the screen. See picture 6-6. The result
will be automatically stored in the monitor.
Picture 6-1
f. After measurement, the monitor will turn off
automatically after 1 minute of no operation.
Alternatively, you can press the "START"
button to turn off the monitor manually.
g. During measurement, you can
press the "START" button to turn
off the monitor manually.
infos Note: Please consult a health care professional
for interpretation of pressure measurements.
7 Displaying Stored Results
"
a. In Clock Mode, press "MEM" button, the
r
monitor will display sign of current group.The
rd-
amount of results in current user memory
e
zone will be displayed. See picture 7-1. Press
.
"START" button to switch group, press "MEM"
ee
to confirm current group. The current
Picture 6-2 Picture 6-3 Picture 6-4 Picture 6-5
bank can also be confirmed automatically
after 5 seconds with no operation.
b. Then LCD will display the average value
of all results in the current bank. See picture
7-2. If no result stored in the current user
memory zone, LCD will display "0" for blood
pressure and pulse rate. See picture 7-3.
c. Press "MEM" button, the LCD will display
the average value of the last three results in
the current user memory zone. See picture
7-4. If no result stored in the current user
memory zone, LCD will display "0" for blood
pressure and pulse rate. See picture 7-5.
d. Press "MEM" button again, the
memory number in the current user
memory zone will be displayed. See picture
7-6. If the monitor has no result stored
in the current user memory zone, the
LCD will display "0" . See picture 7-7.
e. Then the most recent result will be
displayed with date and time stamp. See
picture 7-8. Irregular heartbeat symbol
(if any) and blood pressure classification
indicator will blink at the same time. Press
Picture 6-6
"MEM" button repeatedly to review the
results measured previously. If the monitor
has no result stored in the current user
memory zone, the LCD will display "0" for
blood pressure and pulse rate. See picture 7-9.
f. When displaying the stored results, the mon-
itor will turn off automatically after 1 minutes
of no operation. You can also press the button
"START" to turn off the monitor manually.
Picture 7-1 Picture 7-2
Picture 7-8 Picture 7-9
EN
FR NL DE
Picture 7-3 Picture 7-4 Picture 7-5 Picture 7-6 Picture 7-7
9
WBPM-110 / 64