Setup And Operating Procedures - Lanaform WBPM-110 Manuel D'instructions

batteries and the unit out of the reach
of children and disabled persons.
8. SETUP AND OPERATING
PROCEDURES
1 Battery Loading
a. Open battery cover at the back of the
monitor.
b. Load two "AAA" size batteries.
Please pay attention to polarity.
n
c. Close the battery cover. When LCD
shows battery symbol
batteries with new ones. Rechargeable
batteries are not suitable for this monitor.
Remove the batteries if the monitor will
not be used for a month or more to avoid
relevant damage of battery leakage.
d
report_p Avoid the battery fluid to get in
your eyes. If it should get in your eyes,
immediately rinse with plenty of clean
water and contact a physician.
:
must be disposed of according to local
regulations at the end of their usage.
n,
2 Clock And Date Adjustment
a. Once you install the battery or turn off the
monitor, it will enter Clock Mode, and LCD
will display time and date. See picture2.
b. While the monitor is in Clock Mode,
press the "START" and "MEM" button
simultaneously for two seconds, then release
e
the buttons, the monitor will be in
Clock and Date Adjustment Mode.
c. In Clock and Date Adjustment Mode,
the time format will blink at first. See
picture2-1. While time format is blinking,
press the button "MEM" to change the time
t.
format. The default time format is 24h.
d. Press the button "START" repeatedly, the
year (range is 2018~2099), month, day, hour
, replace all
The monitor, the batteries and the cuff,
and minute will blink in turn. See picture2-
2&2-3 & 2-4 & 2-5 & 2-6. While the number is
blinking, press the button "MEM" to increase
the number, keep on pressing the button
«MEM», the number will increase faster.
e. During adjusting clock and date, the
monitor will go back to Clock Mode
automatically when no button will
be pressed within 60 seconds.
f. You can turn off the monitor by pressing
"START" button when the minute is blinking,
then the time and date is confirmed.
Picture 2 Picture 2-1 Picture 2-2 Picture 2-3
Note: 1.1 The clock format could be set by user.
1.2 Table 2-1 instructs the conversion relations
between 24 hour format and 12 hour format.
Table 2-1
24 hour 12 hour
format format
0:00 12:00 AM
1:00 1:00 AM
2:00 2:00 AM
3:00 3:00 AM
4:00 4:00 AM
5:00 5:00 AM
6:00 6:00 AM
7:00 7:00 AM
8:00 8:00 AM
9:00 9:00 AM
10:00 10:00 AM
11:00 11:00 AM
WBPM-110
EN
FR NL DE
Picture 2-4 Picture 2-5 Picture 2-6
24 hour 12 hour
format format
12:00 12:00 PM
13:00 1:00PM
14:00 2:00 PM
15:00 3:00 PM
16:00 4:00 PM
17:00 5:00 PM
18:00 6:00 PM
19:00 7:00 PM
20:00 8:00 PM
21:00 9:00 PM
22:00 10:00 PM
23:00 11:00 PM
7
/ 64