Maintenance Of The Hood - Novy Touch 894 Mode D'emploi Et D'installation

4.3 Maintenance of the hood

Please allow the lights to cool down sufficiently before
cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
Replacement of the fluorescent lighting
Remove first the electrical plug from the electrical point.
4.4 Remove the cover plate
• Open the cover plate (A) by pulling it down.
• Remove the cover plate (A) by converting the adjusting
clips (B). Don't loosen the screws completely!
• Click the cover plate (A) loose with a light descending
push.
• When you want to replace the cover plate (A) don't
forget to replace the adjusting clips over the plugs
and to tighten the screws.
Remove the grease filter
• Remove the grease filter to get acces to the screws
witch hold the glass panels (see maintenance).
Remove the glass panels
• Loosen First the screws before you remove the glass
panels (A).
• Tip the glass panel (A) over the filterholder (B)
• Watch out: Support the glass panel with the integrated
command, so the cable (C) that lies underneath
doens't get damaged.
Cleaning the glass panels and cover plate
• Don't put the panels and the cover plate in the dish-
washer and don't plunge them in water completely.
• Keep the control dry while cleaning the glass panel.
Replacement of the lights
• Turn the fluorescent lights with a quarter turn to take
it out of its support.
• Place the new light in its support and turn again witha
quarter turn until you hear a clicking sound.
Model
Novy reference
Reference lamp
Model
Novy reference
Reference lamp
Replacement of the starter (894 - 895):
894/895
894.025
T5 L13W/840
896/897/898/899
898.025
T8 F25W/33"/840
EN 20