Process Control Sheet - SEAL 62Base Manuel D'utilisation

7 PROCESS CONTROL SHEET

Note:
We recommend that you make a photocopy of this page. With each successfully run
application, record the process and settings and a diagram of the webbing procedure. Keep the
record so the application can be repeated at a later date.
Hint:
If a standard image is made available for each new process then sales materials and samples
can be developed for reference.
LAMINATOR SETTINGS
Media: _______________________________
Process: _____________________________
Application Use: _______________________
Upper Unwind Shaft: ____________________
Lower Unwind Shaft: ____________________
Wind-up Shaft: ________________________
Front Control Panel Settings
Main Roller Pressure: ___________________
Motor Speed Setting: ___________________
Heat Assist: [On/Off] ___________________
WEBBING SETTINGS
Web Tension Upper Unwind Shaft:
Light / Med. / Heavy ____________________
Web Tension Lower Unwind Shaft:
Light / Med. / Heavy ____________________
Images: Sheet Fed / Roll Easel ___________
Top Splitter: [Over/Under] _______________
Bottom Splitter: [Over/Under] ____________
32
Figure 23: Blank Webbing Diagram
User Manual 62Base