Placing & Answering Calls - Clarity XLC 3.4 Guide De L'utilisateur

PLACING & ANSWERING CALLS
XLC3.4
TO PLACE A CALL:
1. Press TALK, then dial the number
using the numeric keypad. See
lighting pattern for the TALK button
on the bottom of the page.
2. Adjust the volume to the most
comfortable level - using the Volume
Control and BOOST button (if
necessary).
3. Press the TONE button on the
side of the handset to adjust the
tonality of the incoming voice to
the most comfortable level.
WARNING: VOLUME MAY BE
LOUD!
NOTE:
1. If the Voice Assist function is
enabled, you will hear the digits of
the incoming phone number.
2. Step 1 above can be replaced with
one of the following options:
• Dial from CID records: Choose a
record from your Caller List (see
page 17), then press TALK.
• Dial from PHONEBOOK: Choose a
record from your Phonebook (see
page 18), then press TALK.
• Pre-dial: before pressing TALK,
dial the number you wish to call;
digits will display on the screen;
press TALK when the number is
complete.
Follow with steps 2-3 above to
enjoy a clear and comfortable phone
conversation.
TO ANSWER A CALL:
1. When phone is ringing, press
TALK to answer the call.
2. Adjust the volume and tone of the
incoming voice according to your
preferences.
3. When finished, press TALK to
hang up.
NOTE:
1. For an explanation of the TALK
button light, see the bottom of the
page.
2. If you have CID service, note the
incoming phone number displayed
on your screen.
3. If the Voice Assist function is
enabled, you will hear the digits of
the incoming phone number.
4. At any point during the
conversation, press the
speakerphone button
switch to handsfree mode. Use the
volume control for adjusting the
level of the incoming audio. Switch
back to earpiece mode by pressing
the speakerphone button again.
Talk Button Lighting Pattern
Green: Phone is in use.
Flashing Green every 15 seconds in
standby mode: Low batteries.
E
N
G
L
I
S
H

to
17