Initial Display Configuration; Connection To An External Thermostat; Control Panel - termovana Anna Manuel D'utilisation

8

INITIAL DISPLAY CONFIGURATION

When the stove is turned on, the display shows the operating status. During the initial start-up, the display shows
the stove model and the installed firmware release.
The stove must be powered using the ON/OFF safety switch located at the back; after a few seconds it is ready
for ignition.
The stove will modulate its power based on the set ambient temperature, which is detected by the probe on-
board the stove.

8.1 CONNECTION TO AN EXTERNAL THERMOSTAT

Function not active in this version.
9

CONTROL PANEL

A
B
C
A - SET User Menu
B - AUTO to enable the weekly programmer
C - ON/OFF and exit from Menu functions
D - Temperature setting + and menu functions
D - Temperature setting – and menu functions
F - Heating programme setting+ and menu functions
G - Heating programme setting – and menu functions
H - Remote control infra-red sensor
I - Alphanumeric 16x2 LCD Display
9.1 USE OF PANEL
Press SET (A) to open the user menu. Scroll the menu using the keys
To open the submenu, confirm using the
1 - Set Date and Time
2 - Weekly programmer setting
3 - Thermostat mode
4 - Stove parameters
5 - Error log
6 - Language selection
7 - Fuel selection
I
SET (A) key.
02/2021 - EN
D
H
E
and
F
G
.
17