Passion Dream 7 Mode D'emploi page 28

SALT SYSTEM MANUAL
IMPORTANT: Make sure to put the saltsystem control on '0' , every time before draining the spa
water
Required materials:
- Salt TRU-BLU.
- Test strips sodium bromide.
- Test strips aquachek total bromine.
- PH-
- PH+
Fill up the spa with water and add the indicated amount of salt. To calculate the right amount of
salt in gram for your spa, you can multiply the liters in your spa with 1.4. For the number of liters
in your spa, see the back page.
Go through the normal start up procedure of the spa. Switch on the jet at a high speed.
Add TRU-BLU to the water with a dosage of 2 grams per litre. Apply evenly to the water.
Leave the jet on for 15 minutes at a high speed.
Test the amount of salt in the water by using GENESIS SODIUM BROMIDE test strips. The ideal
values are between 7,8 and 8,0. Carry out this test once every two months.
This test is carried out as follows:
• Take a cup, fill it with approximately 2,5 cm of water from the spa.
• Take a sodium bromide test strip and put it in the cup with the yellow edge pointing upwards.
• Wait until the yellow edge turns black and read the values. The ideal values are between 7,8 -8.
• By adding one lid full of TRU-BLU, the sodium bromide values will increase about 0,4.
28