Passion Dream 7 Mode D'emploi page 24

Filtration
The system is factory-programmed with one filter cycle
(Be sure to set the time-of-day properly). The filter time and duration
are programmable. Refer to the TP900/800 User Guide (40985) for
detailed instructions. A second filter cycle can be enabled as needed.
Dual Temperature Ranges
This system incorporates two temperature range settings with inde-
pendent set temperatures. The High Range can be set between 80°F and 104°F.
The Low Range can be set between 50°F and 99°F. Low Range may be economical
during non-use periods. See "Settings" on the Main Screen. Restricted temperature
ranges may determined by the manufacturer.
Ready and Rest Modes
If the filtration pump is a 2-Speed Pump 1, Ready Mode will circulate water every 1/2 hour, using
Pump 1 Low, in order to maintain a constant water temperature, heat as needed, and refresh the
temperature display. This is known as "polling."
Rest Mode will only allow heating during programmed filter cycles. Since polling does not
occur, the temperature display may not show a current temperature until the filtration pump has
been running for a minute or two. Ready in Rest Mode may appear when Jets 1 is activated.
Note: After 3-5 minutes the display will automatically go into sleep mode, which turns the
display off. This is normal operation. Press any button on the screen to wake the panel up.
102 F
High Range
Set: 104 F
8:32 PM
Ozone
Filter 1
Ready in Rest Mode
Heating
Spa
Shortcuts
Settings
24