Passion Dream 7 Mode D'emploi page 16

Diagnostic Messages
Message Meaning
No message on display. Power has been
cut off to the spa.
Temperature unknown.
"Overheat" - The spa has shut down. One
of the sensors has detected 118°F/48°C
at the heater.
"Overheat" - The spa has shut down.
One of the sensors has detected that the
spa water is 110°F/43°C.
"Ice" - Potential freeze condition detected. No action required. The pump and blower will automatically
Spa is shut down. The sensor that is
plugged into the Sensor "A" jack is not
working.
Spa is shut down. The sensor that is
plugged into the Sensor "B" jack is not
working.
Sensors are out of balance. If alternating
with spa temperature, it may just be a
temporary condition. If flashing by itself,
spa is shut down.
A significant difference between tempera-
ture sensors has been detected. This
could indicate a flow problem.
Persistent low flow problems. (Displays
on the fifth occurrence of "HL" message
within 24 hours.) Heater is shut down,
but other spa functions continue to run
normally.
Possible inadequate water, poor flow, or
air bubbles in detected in the heater. Spa
is shut down for 15 minutes.
Inadequate water detected in heater.
(Displays on third occurrence of "dr"
message.) Spa is shut down.
Warning! Shock Hazard! No User Serviceable Parts. Do not attempt service of this control system.
Contact your dealer or service organization for assistance. Follow all owner's manual power connection
instructions. Installation must be performed by a licensed electrician and all grounding connections
Action Required
The control panel will be disabled until power returns. Spa
settings will be preserved until next power up.
After the pump has been running for 2 minutes, the tempera-
ture will be displayed.
DO NOT ENTER THE WATER. Remove the spa cover and
allow water to cool. Once the heater has cooled, reset by
pushing any button. If spa does not reset, shut off the power
to the spa and call your dealer or service organization.
DO NOT ENTER THE WATER. Remove the spa cover and
allow water to cool. At 107°F/42°C, the spa should automat-
ically reset. If spa does not reset, shut off the power to the
spa and call your dealer or service organization.
activate regardless of spa status.
If the problem persists, contact your dealer or service organi-
zation. (May appear temporarily in an overheat situation and
disappear when the heater cools.)
If the problem persists, contact your dealer or service organi-
zation. (May appear temporarily in an overheat situation and
disappear when the heater cools.)
If the problem persists, contact your dealer or service orga-
nization.
Check water level in spa. Refill if necessary. If the water
level is okay, make sure the pumps have been primed. If
problem persists, contact your dealer or service organization.
Follow action required for " HL" message. Heating capability
of the spa will not reset automatically; you may press any
button to reset.
Check water level in spa. Refill if necessary. If water level
is okay, make sure the pumps have been primed. Press
any button to reset, or this message will automatically reset
within 15 minutes. If problem persists, contact your dealer or
service organization.
Follow action required for "dr" message. Spa will not auto-
matically reset. Press any button to reset.
must be properly installed.
16