Initial Start-Up - Passion Dream 7 Mode D'emploi

VL260

Initial Start-up

When your spa is first actuated, it will go into Priming mode, indicated by "PR." Please see the M-7
Installation Instruction Manual for complete instructions on Power-up and Pump Priming. The
Priming mode will last for less than 5 minutes (press "Temp" or "Set" to skip Priming Mode) and
then the spa will begin to heat the spa and maintain the water temperature in the Standard mode.
Temp/Set (80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is constantly dis-
played on the LCD. Note that the last measured spa temperature displayed is current only when
the pump has been running for at least 2 minutes.
To display the set temperature, press the "Temp" or "Set" pad once. To change the set temperature,
press the pad a second time before the LCD stops flashing. Each press of the "Temp" or "Set" pad
will continue to either raise or lower the set temperature.
If the opposite direction is desired, release the pad and let the display revert to the current water
temperature. Press the pad to display the set temperature, and again to make the temperature
change in the desired direction.
After three seconds, the LCD will stop flashing and display the current spa temperature.
Note: If there is not a blower on the system, an alternate panel with separate "Up" and "Down"
buttons in place of a "Set" or "Temp" button may be used. Simply press "Up" or "Down" where a
"Temp" or "Set" button press is indicated. (Ignore the "direction reversal paragraph.")
Jets
Touch the "Jets" button once to activate the low speed of the pump and again for the high speed.
Press the "Jets" button again to turn off the pump. If left running, the low speed of the pump will
automatically turn off after 4 hours, and the high speed will automatically turn off after 15 minutes.
The low speed of the pump runs when when the blower is on. It may also activate for at least 2
minutes every 30 minutes to detect the spa temperature and then to heat to the set temperature if
needed, depending upon mode. When the low speed turns on automatically, it cannot be deacti-
vated from the panel; however, the high speed may be started.
Blower (optional)
This button is used to turn the blower on and off. If left on, the blower automatically turns off after
15 minutes.
Blower Jets Jets Temp Light
Jets Jets Jets Temp Light
14