Passion Dream 7 Mode D'emploi page 20

With the item 'HOLD' you can switch off the pumps, whenever you'd like to clean
your spa or replace the filter. When pressing one of the arrow buttons, the spa will
shut off the pumps during one hour, unless you turn of this mode manually.
Here you can set the start time and duration of the filtration cycle 1 ('FLTR1'). When
the image left is displayed, press one of the arrows. The display shows 'BEGN'. To
set the start time, press one of the arrow buttons again. You can now set your start
time. This works the same way as setting the time. (See Time-item) The only differ-
ence is that all minutes can be adjusted by 15 minutes each press. Confirm the start
time. The display shows 'RUN HRS'. If the start time was already entered correctly
when BEGN was displayed, one could have pressed the Light button directly.
To set the run hours, follow the same steps as described above. When confirmed,
the display reads 'F 1 ENDS xx:xx', the hour the cycle stops is shown on the display.
Don't forget to confirm the times!
Filtration cycle 2 is not initialized by default. We do however advise to turn this cycle
on. When this image is displayed on your display, press one of the arrow buttons.
The display will read 'OFF'. To set cycle 2, press the arrow button again. The display
will read 'ON'. When confirmed, you will be able to set the filtration cycle 2. Follow
the steps regarding setting up filtration cycle 1 to adjust these.
This menu item is adjusted en pre installed by us. No alterations are required in this
menu. If any alterations have been made which have consequences for your spa,
please inform you distributor.
This menu item is adjusted en pre installed by us. No alterations are required in this
menu. If any alterations have been made which have consequences for your spa,
please inform you distributor.
20