Channel Tuning Configuration - Promax Premium 10 Mode D'emploi

USER'S MANUAL. PROMAX-10
When pressing again the rotary selector
carries out a new measurement. If the selector rotary is pressed twice, you will access
the screen of Power and C/N ratio measurement again (section 4.2.3.1.4).
Figure 22.- Constellation Diagram representation and
Pre-BER, Post-BER and MER measurement in a digital channel.
4.2.3.1.6

CHANNEL Tuning CONFIGURATION

In CHANNEL-FREQUENCY mode, when the instrument works in channel
tuning, if you press the CONFIG key [14] you will access the first page of the
configuration menu of the parameters relating on this mode (Fig.23).
The parameters which may be changed and
their values range are shown in the following table.
The parameters are different depending on the
channel, whether it is digital or analogue.
To define a CHANNEL as DIGITAL or
ANALOGUE, you should go to the EDIT
CHANNEL option that is in the GLOBAL
CONFIGURATION menu (see paragraph 4.2.1).
To access the second page of the GLOBAL
CONFIGURATION screen, press again the CONFIG
key [14] (Fig. 24).
To change a parameter value, turn the rotary
selector [9] until the field is activated (it will appear
shaded) and then press the rotary selector, the
value of the parameter will be activated and you will be able to change it by turning the
rotary selector. When the value you want appears, press the rotary selector [9] to
validate it.
Numeric fields such as FREQ. AUDIO, are edited digit by digit, starting from the
lowest weight digit.
CONFIGURATION parameters of ANALOGUE CHANNELS in CHANNEL
TUNING mode.
11/2008
Premium
C21 CCIR
QAM 32/DVB
SR= 6.875
BER: 4.8E-8
BER : 4.7E-8
MER= .28 dB
ALL Locked
Figure 23.- DIG. CH CONFIG. 1/2.
Figure 24.- DIG. CH CONFIG. 2/2.
, the PROMAX-10 Premium
DIG. CH CONFIG: 1/2 ½
CHANNEL BW 7.0 MHz
NOISE FREQ. 3.5 MHz
NOISE MODE F
FCH 0.00 MHz
CONFIG QAM: 2/2
C02 50.50MHz CCIR
ANNEX ITU-T DVB
QAM MOD. QAM 32
SYMBOL RATE BW CANAL 6.875 MHz 7.0 Mhz
ATTEN. AUTO
QUADRANT Q3
Page 27