Tilt Mode Configuration - Promax Premium 10 Mode D'emploi

Repeat the steps 1 to 3 for the 3 following pilots.
4.2.5.1

TILT mode configuration.

Pressing the CONFIG [14] key will
access to the first page of the configuration
menu.
To change a given parameter turn the rotary
selector [9] until the field is activated (this will
appear shadowed) and then press. The value of
the parameter will be activated and may be
changed by turning the rotary selector. When the value you want appears, press the
rotary selector [9] to validate it.
a) BAND
It permits to select between the FORWARD mode (45 to 863 MHz) and the
RETURN PATH mode (5 to 100 MHz).
b) F. PILOT 1
It defines a frequency belonging to the forward band (from 45 to 863 MHz)
where the first measurement of level will be done. This parameter, and the
rest of pilots, is defined digit by digit, by pressing repeatedly and turning the
rotary selector.
c) F. PILOT 2
It defines the second pilot frequency belonging to the forward band.
d) F. PILOT 3
It defines the third pilot frequency belonging to the forward band.
e) F. PILOT 4
It defines the fourth pilot frequency belonging to the forward band.
To access to the second page of the
TILT configuration menu, press the CONFIG
key again. This screen permits to define the
frequencies of the pilots belonging to the return path
(from 5 to 100 MHz). As in previous screen, the
frequencies are defined digit by digit.
To leave the configuration menu of the TILT mode, just press the key of the
operating mode you wish to access.
Page 40
USER'S MANUAL. PROMAX-10
Figure 48.- TILT configuration. 1/2
Figure 49.- TILT configuration 2/2
IMPORTANT
Premium
11/2008