Promax Premium 10 Mode D'emploi page 94

Audio Mode: There are four options to receive the audio signal: LEVEL, AM, FM,
OFF.
In LEVEL mode, the instrument beeps depending on the power
input.
In AM mode, you can listen to AM (Amplitude Modulation) radio
signals.
In FM mode, you can listen to FM (Frequency Modulation) radio
signals.
In OFF mode, the loudspeakers are off.
Press CONFIG again to CONFIGURATION next page (2/2)
The CTB SHOWED parameter allows defining
the method of measurement for the CTB. IN CH
(within the channel) is the suitable method whenever
the carrier of the channel in study can be turned off. If
it is not possible, as approach, any other channel
(free) can be defined for the measurement of the
CTB.
Parameters ∆FCS01, ∆FCS02, ∆FCS03 and ∆FCS04 allow modifying the
frequencies where the CSO is measured (the PROMAX-10
from -2.50 MHz to 2.5 MHz).
The options available on the Configuration menu in the DIGITAL measurement
mode are next:
Freq. Mode: It allows you to change the
measurement signal among ANL
(Analogue), DIG (digital) and LEV
(Power Level).
Freq. Step: It allows you to change the step of
frequency. This is put into
practice when you are using the rotary knob to change frequency.
Channel BW: It allows you to change the channel bandwidth.
Noise Freq.: It allows you to change the noise frequency.
Noise mode: In this mode there are three options: AF (frequency offset), BW/2
(half the bandwidth), FREQ (noise frequency).
Page 34
USER'S MANUAL. PROMAX-10
AN. FR CONFIG:2/ 2
CTB SHOWED
FCS01 1.50 MHz
FCS02 0.75 MHz
FCS03 -0.75 MHz
FCS04 -1.50 MHZ
Figure 35.- AN. FR CONFIG 2/2.
Premium admits values
DIG. FR CONFIG: 1/2
FREQ. MODE
FREQ STEP 0.10 MHz
CHANNEL BW 8.0 MHz
NOISE FREQ. 150.00 MHz
NOISE MODE
Figure 36.- CH-FR configuration.2/2.
Premium
C03
DIG
FREQ
11/2008