Frequency Tuning Configuration - Promax Premium 10 Mode D'emploi

USER'S MANUAL. PROMAX-10
4.2.3.2.4

FREQUENCY Tuning CONFIGURATION

From the FREQUENCY TUNING mode, press the key CONFIG and then it will
appear the Configuration menu related to the frequency tuning.
Depending on the type of measurement, the Configuration menu changes.
There are three types of measurements in frequency tuning: ANALOGUE, DIGITAL
and LEVEL. Each one can be selected from the FREQ. MODE option on the
CONFIGURATION menu.
The options available on the Configuration
menu in the LEVEL measurement mode are next:
Freq. Mode: It allows you to change the
measurement signal among ANL
(Analogue), DIG (digital) and LEV
(Power Level).
Freq. Step: It allows you to change the step of frequency. This is put into
practice when you are using the rotary knob to change frequency.
Audio Mode: There are four options to receive the audio signal: LEVEL, AM, FM,
OFF.
In LEVEL mode, the instrument beeps depending on the power
input.
In AM mode, you can listen to AM (Amplitude Modulation) radio
signals.
In FM mode, you can listen to FM (Frequency Modulation) radio
signals.
In OFF mode, the loudspeakers are off.
The options available on the Configuration menu in the ANALOGUE
measurement mode are next:
Freq. Mode: It allows
measurement signal among ANL
(Analogue), DIG (digital) and LEV
(Power Level).
Freq. Step: It allows you to change the step of
frequency. This is put into practice
when you are using the rotary
knob to change frequency.
11/2008
Premium
you to change the
CONFIG LEVEL:
FREQ. MODE LEV
FREQ STEP 0.10MHz
AUDIO MODE FM
Figure 33.- Config Level.
AN. FR CONFIG:1/ 2
FREQ MODE ANL
FREQ STEP 0.10 MHz
AUDIO MODE FM
Figure 34.- ANL. FR CONFIG. 1/2.
Page 33