PURE Elan DAB+ Mode D'emploi page 7

FM
To enter FM mode: Press Mode until the display shows FM Mode.
Selecting stations
The first time you select FM radio, Elan DAB+ is set to the lowest frequency in the FM band. On
subsequent selections the last used frequency/station is displayed.
To scan for a station in FM mode press and hold the skip forward or skip back button. Elan
DAB+ scans up through the FM band frequencies, showing the current frequency on the screen
display.
Alternatively, you can short press the skip forward or skip back button to tune in 50 kHz steps.
FM 10:27
Buzz FM
Radio for the
nation
RDS
Now playing information
While FM radio is playing, the screen shows its frequency, or if RDS information is
available, station name and any further RadioText' information. If no information is
available, just the frequency and a No RadioText message is shown.
To view further information about the broadcast press Info. Each time you press Info, the
next set of information is displayed, cycling through:
RDS Radio text programme type
Frequency
Mono/stereo
Power status
Date.
Settings
Scan settings
By default, FM scans stop only at stations with good signal strength .To change
the scan settings, to stop at all stations select Menu > Scan setting > All Stations' .
This may include poor quality audio from weak stations.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this
may result in poor quality audio. The audio quality can be improved using mono.
Options: Stereo allowed | Forced mono
To play weak stations in mono Select Menu > Audio setting > Forced mono.
Bluetooth
To enter Bluetooth mode: Press source to choose Bluetooth mode.
BT Pairing
To connect a Bluetooth capable device. Use your Bluetooth capable smart device to pair
and connect with the Elan DAB+.
Display information
The screen displays either Bluetooth Disconnected or Bluetooth Connected depending
on the connection state.
EN