Removing The Side Panels; Utilizing The Cpu Power Cable Cut-Out; Installing The Motherboard; Installing The Pci-E/Pci Card(S) - Corsair CARBIDE Série Guide D'installation

carbide spec-03
SPEC-03
STEP 01

1. Removing the Side Panels

Simply remove the
thumbscrews then slide the
side panels back and out.
Note: Corsair recommends
removing both side panels and
setting them aside when building
your system to avoid accidental
damage. Both side panels are
interchangeable and should be
removed to reduce clutter.

2. Utilizing the CPU power cable cut-out

To install your flat CPU 8/4 pin
cable, route the cable through
the motherboard tray before

installing the motherboard.

Only Flat Cables will be
compatible and you must split
your cable into 2 pieces to fit
through the cutout.
5
carbide spec-02
STEP 02
carbide spec-03
STEP 03 / ps
3. Installing the Motherboard
First, install your
motherboard's I/O shield (see
your motherboard's manual
for guidance).
Align your motherboard with
the pre-installed standoffs.
Use the provided screws
b
to secure the motherboard to
the motherboard tray.

4. Installing the PCI-E/PCI card(s)

Remove thumbscrews and
corresponding slot cover(s).
Install the add-on card and
secure with thumbscrews.
6