Campbell Hausfeld CE1000 Mode D'emploi page 10

INSTALLATION INSTRUCTIONS (CONTINUED)
Picking the Location
Operate unit at least 18 inches from any
obstructions in a clean, well ventilated area. The
surrounding air temperature should not exceed
100° F. This will ensure an unobstructed flow of air
to cool compressor and allow adequate space for
maintenance.
sandblast areas or any other source of contamination.
NOTE: If compressor operates in a hot, moist
environment, supply compressor pump with clean,
dry outside air. Supply air should be piped in from
external sources.
Assembly Instructions
1. Unbolt the unit from the shipping skid. Use a
ratchet with a 9/16 in. socket. Remove the unit
from the skid. Discard shipping hardware once
removed. See Figure 3.
2. Install rubber feet with nuts and washers. See
Figure 4.
Do not locate the compressor air
inlet near steam, paint spray,
8
18 inches
Figure 2
Shipping
Bracket
Shipping
Bolt
Figure 3
Figure 4
18 inches
Shipping
Bolt
Nut
Rubber Foot