ST Quadrat LUX-top QUICKFIX II Manuel De Montage Et D'utilisation page 25

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Application / system description:
®
The
LUX-top
QUICKFIX II
personal fall protection equipment, which can be attached using a clamp fastening device
to steel structures with adequate load-bearing capacity, taking account of the minimum
requirements specified in the installation instructions.
It is also possible to leave the anchor device permanently on the building.
®
LUX-top
QUICKFIX II
The maximum force that is introduced to the structure by the anchor device in the case of
a fall is 12 kN.
®
The
LUX-top
QUICKFIX II
persons with full body harnesses and energy absorbers (including 1 person for first aid /
rescue purposes).
Even an anchor point already deformed by a fall can still normally be used to rescue a
person who has fallen from a height.
The attachment to the
element (carabiner pursuant to EN 362) on the PFPE in accordance with its instructions for
use.
Before every use of the system, the user must check whether the anchor point is
correctly fixed to the steel construction.
Only then can the PFPE be fastened to the anchor point.
®
LUX-top
QUICKFIX II
EN 363:2008:
Restraint systems
Fall arrest systems
Rescue systems
The respective user instructions of the other PFPE and abseiling and rescue
equipment used must also be observed!
®
LUX-top
QUICKFIX II
rope access techniques (abseiling work etc.)!
®
The
LUX-top
QUICKFIX II
®
LUX-top
QUICKFIX II
User instructions (including installation instructions)
Material used for the anchor point: Stainless steel W1.4301 / AISI 304
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.lux-top-absturzsicherungen.de
system is a transportable anchor point for fastening
can be loaded in all directions after correct installation.
anchor device is approved for simultaneous use by 3
®
LUX-top
QUICKFIX II
can be used in the following fall protection systems according to
is not suitable as an anchor point for suspension systems using
anchor device consists of the following components:
anchor point complete
page 7 version 07/2019
system is made by means of a connecting

Publicité

Table des Matières
loading

Table des Matières