Publicité
Les langues disponibles
Les langues disponibles
Fitting instructions
Fitting of the tow bar:
Note: Before starting to mount your tow bar we strongly recommend to read very carefully the fitting
instructions and to search for the fixing points on the vehicle.
1) Loosen the 4 bolts of the bumper
2) Position the tow bar underneath the vehicle and attach it to the vehicle by using the 4 bolts that previously have
been loosened (the plates B have to be placed between the chassis and the bumper fixation holes)
3) Fit the tow bar to the bottom of the trunk by using 4 bolts (2) of 8 x 25 and 4 washers (R) ø 8 LL (inside trunk)
after the holes were drilled with ø 8mm.
4) Tighten all the bolts (according to the turning moments in the chart)
*Since the tow bar with reference number above has been designed to tow the maximum weight given by the
car manufacturer for this model, it is recommended to check the manual in order to find out the maximum
towing weight and the maximum weight on the tow ball that are allowed for your car model.
RECOMMENDATIONS:
1) Tighten all bolts again after having used your tow bar for more than 500km
2) Despite the high protection quality of the bolts, it is recommended, in order to be able to demount your tow bar
easily afterwards, to finish this protection after having tightened the bolts with a product such as paint, mastic
or a corrosion resisting coating etc...
Composition
1 tow bar reference 04090
1 flange-ball 740.000
2 bolts M16x45
2 security washers M16
2 nuts M16
1 security shackle (-s)
4 bolts M8x30
4 security washers M8
4 nuts M8
4 washers 25x8,4x2
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
Renault R4
1963 - ....
Ref. 04090
(*)
(*)
(*)
(*)
(*)
(A)
(A)
(A)
(A)
All bolts and nuts : quality 8.8
Publicité
