Publicité
Mercedes CLS (type C219)
10/2006 - ....
Ref. 1669T30
Fitting instructions
1)
Remove the exhaust and the bumper. Remove the coverings in the trunk, also remove the plastic cup
(where the compressor is hidden).
2)
Remove the buffer beam and permanently remove the buffer beam supports.
3)
Remove the rubbers from the chassis beams in the trunk.
Shove the plastic caps over the carrying arms (1) and (2) till on points (B)( figure see below).
Slide the mounting pieces (1) and (2) with points (A) in the free holes at the back of the chassis
beams till points (B) come against the backplate of the vehicle with the plastic caps between the
carrying arms and the rear plate. Insert the mounting pieces (6) at point (A) and mounting pieces (5)
at point (B), insert the necessary bolts, washers and nuts, but do not tighten them.
4)
Place the tow bar in between the mounting pieces till points (C) and (C') of the tow bar fit those of
the mounting pieces. Add the mounting pieces (3) and (4) to the outside of the mounting pieces.
Insert the necessary bolts, washers and nuts but do not tighten them.
Install the buffer beam on point (D) of the mounted pieces (3) and (4) and reinsert the original bolts.
Tighten everything firmly.
5)
Put everything of point 1 back on its place.
Install the (*) and also tighten firmly
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
Publicité
