Operation; Vacuum Cleaning; Accessory Chamber - Fakir Prestige C 240 Mode D'emploi

Vacuum cleaning

Q
P
D
32

Operation

WARNING!
Check the appliance and the power cable before use. Faul-
ty appliances may cause injury and should not be used.
A crevice nozzle [Q] and an upholstery nozzle [P] are
stored in the accessory chamber. To open the accesso-
ry chamber lid [J], press the two unlocking buttons at
the same time.
● Attach the required nozzle.
● Pull out the power supply cable by tugging on the plug un-
J
til the required length is reached. A yellow mark on the ca-
ble shows you that the maximum cable length has almost
G
been reached. The maximum cable length is shown by a
red mark on the cable. Never pull the cable out of the ap-
H
pliance beyond the red mark.
● To switch the vacuum cleaner on, press the ON-OFF foot
button [H]. If pressed again, the appliance switches off.
● Set the required suction level using the suction power re-
gulator [G].
NOTE!
When the dust bag or filters are full, or if the accessories
are blocked (hose, pipe, nozzle), the 'change filter' lamp
will shine [D]. To ensure correct analysis, the maximum
suction level [G] needs to be set and the floor nozzle needs
to be lifted from the floor.
In this case, change the dust bag or blocked filter or reme-
dy the blockage.