Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Taking a shower
The system is in "sleep" mode
(OFF). This is indicated by a
dot flashing in the display.
Pressing any button switches
the system to "stand-by" mode
(ready for use).
The display now has back-
ground lighting and the
buttons have dimmed back-
ground lighting. The control is
ready for operation.
One or two different shower
types can now be activated.
The buttons have bright back-
ground lighting. Dark buttons
cannot be selected. Pressing
an active button resets this
button and a different shower
type can then be selected.
Examples of shower
type combinations:
Example 1:
,
Overhead and body showers
Example 2:
,
Hand and body showers
Example 3:
,
Overhead and hand shower
Setting the temperature
Use the +/- (
and
)
buttons to st the temperature.
For temperatures above 42°C
(protection against scalding):
Press the + (
) and >42°
buttons (
) simultaneously.
Pressing the Mode (
)
button again: Return to
temperature setting >42°.
Protection against
scalding:
Protection against scalding
hinders setting temperatures
above 42°C.
Comfort Electronics K4,
Operation, Maintenance, Troubleshooting
Hydromassage
(cascade)
First activate the Body shower
(
Hydromassage (
Upper and lower body
shower pairs are switched
parallel. Cascade switches
automatically between these
4 showers and the middle
body showers.
Note: Varying temperatures
during hydromassage
improve the stimulation effect
on your circulation.
Press the Mode (
to change the interval.
The word "Pulse" appears in
the display followed by a
number. This number is the in-
terval in seconds. The +/- (
and ) buttons can be used
to set the interval to
1 – 50 seconds.
) button. Then press the
) button.
) button
33
Publicité
Table des Matières
