Fitting The Headrest - Invacare Aquatec Ocean VIP Manuel D'utilisation

Aquatec® Ocean VIP / VIP XL / Dual VIP
Adjusting the inclination of the foot plates
IMPORTANT!
– The inclination of the foot plates can be adjusted
infinitely variably.
– Make sure, the right and left foot plate is adjusted in
the same way.
1. Loosen the Allen screw C on the foot plate using a size 4 Allen
key.
2. Turn the foot plate D to the desired position.
3. Tighten the Allen screw again.

Fitting the headrest

Use the star handle F to insert the screw a little into the
1.
bracket G.
2. Push the bracket with the screw onto the handle of the backrest
E from behind in such a way that the screw engages in the hole
of the backrest's handle.
3. Insert the plate D into the bracket from the front in such a way
that both lugs of the plate face down and up and the curved plate
side touches the handle of the backrest.
14
IMPORTANT!
– On inserting the retainer, make sure that the curved
side of the plate rests entirely on the handle of the
backrest.
4. Push the grab handle C from above into the recesses of the
bracket.
5. Use the star handle to tighten the screw until the grab handle
is fixed.
Push the pad J and the pad holder B into the holder on the
6.
grab handle H.
Use the star handle A to tighten the upper screw until the pad
7.
holder is fixed.
To adapt it to the user, the grab handle can be fitted with
the curve facing the front or the back.
The headrest pad J can be removed and replaced by other
pad shapes (optional). To remove it, loosen the retaining
bolts I.
1563142-B