Erase The Memory; To Open The Door Manually - Chamberlain B4603TC Manuel D'installation

Operation

Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately
6 seconds). All remote control and keyless entry codes are now erased. Reprogram any accessory you
wish to use.
ERASE ALL REMOTE CONTROLS, KEYLESS ENTRIES, AND myQ® DEVICES FROM
GARAGE DOOR OPENER
Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6
1.
seconds).
Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now
2.
erased. Reprogram any accessory you wish to use.
ERASE THE CONNECTION FROM GARAGE DOOR OPENER TO HOME Wi-Fi® NETWORK
1. Press and hold the black adjustment button on the garage door opener until 3 beeps are heard
(Approximately 6 seconds).
ERASE THE CAMERA SETTINGS
1. Press and hold the reset button on the side of the camera for 10
seconds. The LED light will turn off, then flash red.
You will need to set up your camera again after resetting it.

To Open the Door Manually

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED.
l
Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or
unexpectedly.
NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
l
NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
l
DISCONNECT THE TROLLEY
The door should be fully closed if possible.
1.
Pull down on the emergency release handle so the trolley release arm snaps to the vertical position.
2.
The door can now be raised and lowered as often as necessary.
LEARN
Button
Adjustment
Button
TO RE-CONNECT THE TROLLEY
Pull the emergency release handle toward the garage door opener so the trolley release arm snaps to the
1.
horizontal position. The trolley will reconnect on the next UP or DOWN operation, either manually or by
using the door control or remote control.
Reset
Button
39