Remote Control; Cleaning And Maintenance; Problems And Solutions - FUAVE SV7010 Manuel D'instructions

Remote control

The Fuave SV7010 has a remote control. Once the fan is switched on with
the on/off-button then you can use the remote control, which also has but-
tons 2, 3, 4, and 5, to operate it with. Switch the fan off again with the on/
off switch on the fan.

CLEANING AND MAINTENANCE

Switch the fan off and remove the plug from the socket if you wish to clean
the device or perform maintenance.
The fan only needs general, exterior maintenance. Dust it regularly with a
soft cloth or duster or use a vacuum cleaner with a soft brush to clean. If it
is very dirty, open the grille and clean grilles and blades using a soft, damp
cloth and a mild household cleaning agent. Dry everything thoroughly and
allow the fan to dry properly before reassembling and using again. Ensure
that water does not come into contact with anything other than the grille
and blades. Never rinse or spray the fan!
In order to prevent material discolouration or deformities, never use aggres-
sive or corrosive (cleaning) products.
Rub a little oil on the motor shaft at the end of the season to prevent rust.
If the fan is to be stored at the end of the season, repack in its original pack-
aging: this offers the best protection. Store it in a safe and dry place that is
not subject to extremes of heat or cold.

PROBLEMS AND SOLUTIONS

The fan blades do not rotate even though the device is
switched on
• Is the plug in the socket?
• Is there power to the socket?
• Is the blade blocked, e.g. by damage, a deformity on the grille or a
foreign object?
2 1