Publicité
Tailgate Handle Camera for select GM Trucks (2007-2013) Chevrolet / GMC
Installation Guide
Routing the camera wires to backup lead tie in
1
With the Tailgate down extract the (2) Phillips head tap screws
that hold in the driver's side taillight. And remove the taillight.
2
The wiring can either be routed up from the harness below or
routed down then tied into the harness red and black wires.
There is a clear path that the factory wiring goes down the main
harness follow that route.
3
Notice that the backup lamp is at the bottom position of the
taillight. Tie in the LED light leads Red (+) and Black (-) from the
camera to the Green for (+) and Black for (-) of the taillights.
Routing the camera wires to front
1
See illustration below for routing path of of camera data cable
from taillight to dashboard. It will parallel the factory harness and
wire tie to it at regular intervals. There are (10) wire tires supplied
with the kit. Use wire ties for this operation.
Note:
Ensure that the headunit has the Orange/white lead tied in
properly into the backup trigger lead. This will allow the camera
to come on each time the vehicle is placed into reverse
2
Once the cable is routed to the Front seat area under the truck
look for a large round rubber grommet that is an ideal place to
run the cable from the outside to inside the cab. See illustration
below for location.
Driver's seat floor area
3
After entering the cab continue to route the camera data cable
to the back of the radio and connect to the camera input pigtail
cable using the direct connector connection. If dash disassembly
instructions are needed then refer to X009-GM or X009-GM2.
˜ 9/11
Publicité
