Publicité
Tailgate Handle Camera for select GM Trucks (2007-2013) Chevrolet / GMC
Installation Guide
Routing the LED light wires to front
1
Once the cables are routed out of the lower access hole start to
bundle them together and cover with Fluted tubing getting ready
to run wiring to cab.
2
With fluted tubing installed slip one of the two the rubber
grommets over the end and slide it back towards where the cable
exists the tailgate. Careful to make sure the grommet is facing
the correct way for installation.
Feed the cable with tubing installed through the round opening
in the body below the center of the bed. Push the grommet into
place and see illustration below for reference.
3
Routing the cable up to the cab is done by paralleling the factory
harness run on the Driver's side of the truck under the bed.
Note: be careful to allow the back up positive and negative leads
to route to the Driver's rear taillight to connect to the backup
input leads.
˜ 8/11
Publicité
